Create Project Need help?
  • PROJECT STATUS
  • CREATION PERIOD
  • BADGE
Latest comments
gfaman
gfaman 10 minutes ago
Hi Hans, again, sorry for the delay. I looked the code and yes, there is a problem.  In case of 3 detectors, I forgot the line to send the distance to the vibrators. Please find the code corrected, and the .HEX compiled with the 3 detectors and the correction. These files are only for 3 US sensors !  Let me know if it is ok now, Laurent
Back ultrasound radar for bike:
Heinz2
Heinz2 4 hours ago
Thanks for the information. I want to use pin 18 and 19 of the atmega. The display uses no jumper. Gruß Heinz
180348 DIY soldering station
Russin Sir Bullar
Russin Sir Bullar 6 hours ago
WHAT IS HAPPENING ?    NO-ONE IS WRITING ANYTHING !  Did anybody besides me buy and assemble the kit ?? I have a problem:   The OLED-display is not working at all and I don't even know if the program is correct.  The tip gets hot though. What about the pre-compiled code ?  How is that uploaded ?  AVRDUDE ?
180348 DIY soldering station
ElektorLabs
ElektorLabs 1 day ago
It may also be possible to rewire the I2C display for SPI use. Some of these displays have jumpers (0R resistors) that allow to do this. Look up the schematic of your display.
180348 DIY soldering station
TonGiesberts
TonGiesberts 1 day ago
No. The circuit you refer to uses two thyristors anti-parallel. Two different gate signals are needed then, each referenced to the kathode the respective thyristor. Our circuit only generates one gate trigger signal. There is a link to a AC Voltage Controller Kit which has a dedicated trigger circuit for this.
SCR gate pulse generator [180611-1]