Programmer Board for the R8C/13

-

This board is a spin-off of the 10-pound ‘R8C Tom Thumb’ project published in the February 2006 issue of Elektor Electronics.
The author has added an LED behind the 5-V regulator and three small connectors (ground (0V); +5 V on the bottom left) to supply power to potential daughterboards. Connectors are linked to the R8C/13 output ports.

Continue reading this Elektor article?

Try a digital membership (Green) for 6 months for only €5.33 per month.

Unlimited access to online Member Only articles
3 new editions Elektor Magazine (digital)
More than 5000 Gerber files
20% member discount on e-books (at elektor.com)
10% member discount on Products (at elektor.com)

Try for 6 months.
Stops Automatically.

What is Elektor Exclusive?

Materials

060125-PCB.pdf

Component list

Resistors
R1 = 27k
R2,R5 = 10k
R3 = 4k7
R4 = 100k
R6 = 1k
Capacitors
C1,C4 = 10µF/10V
C23,C3 = 100nF
Semiconductors
D1 = 1N4004
D2 = LED, red, dia. 3mm or 5 mm
T1 = BC548C
T2 = BC558C
IC1 = 7805
Miscellaneous
S1 = pushbutton (reset)
S2 = slide switch, lead pitch 2.5 mm (programming)
K1,K2,K3 = 2-way pinheader
K4 = mains adaptor socket
K5 = 9-way sub-D plug (male), PCB mount
2 lengths of 16-way IC socket strip (for R8C module socket)