More about Amplifier (436)

1-02-2000 | The integrated output amplifier described in this article consists of little more than one integrated circuit. It is intended especially for...

1-12-1999 | The OP284 is a low noise dual op amp with a bandwidth of 4 MHz and rail-to-rail input/output operation. These properties make it ideal for...

1-12-1999 | One way of designing a programmable amplifier is placing a HEXcoding switch in the feedback loop of an operational amplifier (op amp). A 1...

1-09-1999 | This short article deals with several matters relating to the booster amplifier described in the July/August issue of this magazine. One o...

1-07-1999 | GENERAL INTEREST PC-controlled model railway: EEDTS Pro the booster amplifier The controller of a model railway is the generic term for the...

1-06-1999 | In the introduction to Part 1 it was stated that the Titan 2000 could deliver up to 2000 watts of ‘music power’, a term for which ther...

1-06-1999 | The TDA8552 from Philips Semiconductors is a two-channel audio power amplifier that provides an output power of 2×1.4 W into an 8 Ω load w...

1-05-1999 | This fourth of five parts deals primarily with the wiring up of the amplifier and ends with a brief resume of its performance and specific...

1-05-1999 | Most domestic amplifiers are cooled solely by convection, but it may happen that a standard heat exchanger does not provide adequate...

1-05-1999 | This is the datasheet for the 2SC5171 device.