About the article

Stepper motor control - part 3:

construction and software

LABSPROJECT
Based on a Labs project | October 2011 | Find it here
Stepper motor control - part 3:
Having built the PCB and secured it to the front panel, you should be ready to take the stepper motor control into use. This is best done in step-by-step fashion (pun intended), and we will guide you from adjusting the step-down voltage regulator right up to operating the PC terminal program. In the unfortunate case of the project not working as expected, help is available in the section ‘Faultfinding’.
Downloading of this magazine article is reserved for registered users only.
Login | Register now!
Loading comments...